MT-1280 Specification
| Counter | 1999 |
| Digits | 3 1/2 |
| Panel size | 61×36mm, 40mm high figure |
| Backlight | N |
| Analog bargraph | N |
| Auto/Manual ranging | Manual |
| DC (V) | 200mV/2V/20V/200V ±(0.5%+3d) |
| 1000V ±(0.8%+10d) | |
| AC(V) | 2V/20V/200V ±(0.8%+5d) |
| 750V ±(1.2%+10d) | |
| DC(A) | 200µA/20mA ±(0.8%+10d) |
| 200mA ±(1.2%+8d) | |
| 20A ±(2.0%+5d) | |
| AC(A) | 20mA ±(1.0%+5d) |
| 200mA ±(2.0%+5d) | |
| 20A ±(3.0%+10d) | |
| Resistance(Ω) | 200Ω ±(0.8%+5d) |
| 2/20/200KΩ ±(0.8%+3d) | |
| 20MΩ ±(1.0%+25d) | |
| Capacitance(µF) | 20nF±(2.5%+20d) |
| 20uF±(2.5%+20d) | |
| 200uF±(5.0%+20d) | |
| Temperature(C) | (-20C~1000C) < 400±(1.0+5d) |
| (-20C~1000C) >= 400±(1.5+15d) | |
| Continuity with beeper | Y |
| Diode test | Y |
| Transistor test | Y |
| Display hold | N |
| USB/RS232 interface | N |
| Automatic power off | Y |
| Low battery indication | Y |
| EN61010-1 CAT II /CAT III | 1000VDC/750VAC |
| Battery | 9V(6F22))×1 |
HAKKO PRESTO SOLDERING IRON
- Boost switch can immediately raise power from 20W in normal operation mode to 130W, enabling high-speed heatup
- The HAKKO Presto can be used for a wide range of applications from simple repair of electric appliances to soldering of large components such as transformers
- Supplied heat-resistant element cover makes it ideal for onsite servicing and repair
- 20W when used in normal operation, but can be heated up to 130W when the boost switch pressed.
| Press the boost switch when a large amount of heat is temporarily required; for example, when quick heatup is needed (the unit becomes ready to solder within around 20 sec.) or when soldering relays and connectors. |
Specifications
| Model No. | 980 | 981 | 984 | 985 |
| Power consumption | 20/130W (While the switch is pushed) | |||
| Heating element | Ceramic heater | |||
| Total length | 205mm | 160mm | 205mm | 160mm |
| Weight | 48g | 92g | 56g | 100g |
Other than items stated above you may also need other tools such as :
- Desoldering Pump/Desoldering Wick
- Flux
- Solder Paste
- Solder Lead
- Things to be repaired :P
That's all for tonight, on the next topic I will be showing you my next try and error project on repairing a PLUS SmartTAG. See ya!!
